Commercial High Speed Design
This PCB Design was mechanically complex and required a section of components to be rotated at +- 15 degrees from the standard rotations which made the routing a little more difficult. This board also had a couple custom ICs that required specific routing and length tuning.

• Custom .5mm pitch Image Processor

• 2Gb NAND + 1Gb DDR Chip

• Custom high speed ASIC

• Multiple A/Ds

• Camera Interface

• RGB/VGA Video Interface

• Blind Vias

             High Speed Design

This PCB Layout was fairly dense and required very tight spacing due to mechanical constraints. This board also had 12x separate 6G SATA lanes and 2x 10G Ethernet lanes. This design utilized a large Xilinx Virtex 7 and utilized many of the available transciever lanes. 

• 1x Xilinx Virtex 7 FPGA

• 2x Microsemi - 10G PHY

• 4x 4Gb DDR3 running at 800MHz Clock Speed

• 6x SGMII (2.5Gb/S)

• 2x Ethernet (10Gb/S)

• 12x SATA III (6Gb/S)

• Complex power supply sequencing

• Via Back-Drilling

• Enpirion Switching Power Supplies

              Industrial Standard Design

This project was fairly simple and did not require any complex mechanical constraints or high speed interfaces. The design did have some anti-aliasing filters that needed symetrical layout.

• Power switchers

• Anti-aliasing filters

• Multi-Channel design

High Speed /Density

This PCB Design was challenging due to the size of the circuit board and density of the components and routing. This board was about 5" x 4" and had 1,600 components. 

• 1x Altera Stratix V FPGA

• 4x 8Gb DDR4

• 1x High precision D/A

• 1x Micosemi Dual Port 1G Ethernet PHY/MAC

• 1x RGB to NTSC Video Encoder

• 1x RGB DAC

• High Density

• SGMII / RGMII signaling

• Via Back-Drilling